46
To change the device to connect
If you have registered several Bluetooth audio players,
select which device is to be connected to the System.
1 Select “SLCT DV (Select device)”.
The name of the current Bluetooth audio player appears.
2 Select the device.
If a Bluetooth connection cannot be established
Try the following if “CANNOT” and “CONNECT” appears
on the display:
Set the Bluetooth audio player ready to make connections
(refer to the device manual for details), press Bluetooth
SETTING repeatedly (while holding SHIFT) to select
“RECEIVE,” then press ENTER/SET.
(while holding...)
(Exit setting)
To select a track: To pause: To stop:
To pause, press
once or hold one
second. (It depends
on Bluetooth audio
player.)
To release, press
the same button
again.
• You can operate the Bluetooth audio player by using the
buttons above when the Bluetooth audio player supports
AVRCP profile.
• Some Bluetooth audio players may not be controled by
the System.
To turn off the sound from the Bluetooth audio player
temporarily
Press Bluetooth SETTING repeatedly (while holding
SHIFT) to select “CANCEL,” then press ENTER/SET.
To resume the sound, press Bluetooth SETTING
repeatedly (while holding SHIFT) to select “RECEIVE,”
then press ENTER/SET.
UX-G980V_U.indb 46UX-G980V_U.indb 46 08.9.11 3:28:37 PM08.9.11 3:28:37 PM
To Next Page
Loading...
Need help?
General
