12
Setting the Clock
Set the clock before using the Daily Timer (see page 20).
• You can set the clock only when the System is turned on.
1 Activate the clock setting mode.
2 Adjust the hour.
3 Adjust the minute.
The built-in clock starts working.
To check the current time (CT) while the System is
turned on
The time is displayed for a few seconds.
If there is a power failure
The clock loses its settings. You need to set the clock
again.
Turning Off the Power Automatically—
Sleep Timer
1 Activate the sleep timer mode.
2 Specify the shut-off time (in minutes).
To check the time remaining until the shut-off time
• If you press the button repeatedly, you can change the
shut-off time.
Changing the Display Brightness
You can dim the display at two levels.
While the System is turned on...
Remote
ONLY
2 sec.
2 sec.
10 20 30 40 50
90 80 70 60
(Canceled)
OFF
2 sec.
Dimmer 1 Dimmer 2
Dimmer off (canceled)
Body-UX-TB30[B].fm Page 12 Friday, October 23, 2009 9:31 AM
To Next Page
Loading...
