23
Daily Operations—Sound & Other Adjustments
(see pages 11 and 12)
Adjusting the Volume:
• Be sure to turn down the volume before connecting or
putting the headphones.
Adjusting the Sound:
• This function also affects the sound through the headphones.
Setting the Clock:
• “0:00” flashes on the display until you set the clock.
• The clock may gain or lose 1 to 2 minutes per month. If this
happens, set the clock again.
Advanced Disc/USB Mass Storage Class
Device Operations
(see pages 15 to 17)
Programming the Playing Order—Program Play:
• If you try to program a 33rd track, “PROGFULL” appears
on the display.
Daily Timer Operations (see pages 20 and 21)
• When you unplug the AC power cord or if a power failure
occurs, the timer will be canceled. You need to set the clock
first, then the timer again.
Maintenance
To get the best performance of the System, keep your
discs, and mechanism clean.
Handling discs
• When removing the disc from its case, hold it at the edge
while pressing the center hole lightly.
• Do not touch the shiny surface of the disc, or bend the disc.
• Put the disc back in its case after use to prevent warping.
• Be careful not to scratch the surface of the disc.
• Avoid exposure to direct sunlight, temperature extremes,
and moisture.
To clean the disc:
Wipe the disc with a soft cloth in a straight line from center to
edge.
Handling USB mass storage class devices
• Do not touch the USB connector.
• Be careful not to damage the USB connector.
• Put the USB connector in the cover or slide in the USB unit
after use to prevent breaking.
Cleaning the System
• Stains should be wiped off with a soft cloth. If the System is
heavily stained, wipe it with a cloth soaked in water-diluted
neutral detergent and wrung well, then wipe clean with a dry
cloth.
• Since the System may deteriorate in quality, it become
damaged or get its paint peeled off, be careful about the
following:
– DO NOT wipe it with a hard cloth.
– DO NOT wipe it strongly.
– DO NOT wipe it with thinner or benzine.
– DO NOT apply any volatile substance such as insecticides
to it.
– DO NOT allow any rubber or plastic to remain in contact
for a long time.
To remove the speaker grilles
ProjectionHoles
Speaker grille
UX-TB30[B].BOOK Page 23 Tuesday, October 20, 2009 4:36 PM
To Next Page
Loading...
Need help?
General
