3
Getting Started
Step 1: Unpack
After unpacking, check to be sure that you have all the
following items. The number in parentheses indicates the
quantity of each piece supplied.
•FM antenna (1)
• Remote control (1)
(A lithium coin battery CR2025 has been installed when
shipped.)
If any item is missing, consult your dealer immediately.
Step 2: Prepare the Remote Control
When you use the remote control for the first time, pull out
the insulation sheet.
Replacing the Battery in the Remote Control
If the range or effectiveness of the remote control
decreases, replace the battery.
Insert the battery into the remote control by matching the
polarity (+ and –) correctly.
• Wrap the battery with tape and insulate when throwing
away or saving it.
Step 1:Unpack the package and
check the accessories.
Step 2:Prepare the remote control.
Step 3: Connect the control cable.
Then connect antenna and
speakers. (See pages 4 and 5.)
Finally plug the AC power cord.
Now you can operate the System.
FM antenna
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Insulation sheet
UX-TB30[B].BOOK Page 3 Tuesday, October 20, 2009 4:36 PM
To Next Page
Loading...
Need help?
General
