16
(2) Select a track.
4 Confirm the selection.
Next program step is indicated.
5 Repeat steps 3 and 4 to program other tracks.
6 Start playback.
The tracks you have selected are played back in the
order you have programmed.
• You cannot select the track with the number buttons
during Program Play.
To check the programmed contents
While the PROGRAM indicator lights up on the display
and playback is stopped...
To modify the program
While the PROGRAM indicator lights up on the display
and playback is stopped...
To skip a track: To pause: To stop:
To release, press
again.
Track number
Program step
Group (folder) number
Edit:
1 Press DISPLAY/PROGRAM repeatedly until the
program step you want to edit is displayed.
2 Perform steps 3 and 4 on pages 15 and 16.
To add step in the program:
1 Press DISPLAY/PROGRAM repeatedly until “00” is
displayed.
2 Perform steps 3 and 4 on pages 15 and 16.
To erase entire program:
The PROGRAM indicator goes off.
Program contents are also erased in the following cases:
• When you open the CD tray while the source is disc.
• When you disconnect the USB mass storage class
device while the source is USB mass storage class
device.
• When you start Random Play.
• When you change the source.
• When you turn off the System.
UX-TB30[B].BOOK Page 16 Tuesday, October 20, 2009 4:36 PM
To Next Page
Loading...
Need help?
General
