18 JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors
2.2 I/O descriptions
- I/O supply and gnd (IO- and O+).
Used as ground and supply for the user in/output (O1 and IN1).
- 2 RS422/RS485 Multifunction I/O channels
Only available at the MAC00-Ex41. Can be used for encoder input, full duplex
serial communication, encoder output etc.
Please notice that no multifunction I/O’s are available if mounted in a MAC050-
MAC141.
• “PWR” connector.
- 24V supply for the internal control circuitry in the motor.
To Next Page
Loading...