JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors 183
8.2 Commisioning
8.2.4 Setting the slave address
The Sercos
®
IDN S-0-1040 is the device address. This parameter can be written using
the JVL MacTalk application. The address setting must be unique, meaning each address
must only be used once in a Sercos
®
network. Sercos
®
also supports automatic slave ad-
dressing. If you enter the address 0 for all slave devices, the addressing is executed auto-
matically by the master at power-up, if the used master supports automatic addressing.
8.2.5 Quick start with Pack Profile and Bosch-Rexroth MLC/XLC master.
This paragraph guides you through the steps needed to jog the motor with PackProfile
(Sercos
®
drive). With the Pack Profile no SDDML file is needed.
To Next Page
Loading...