184 JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors
8.2 Commisioning
8.2.5.1 Enabling FSP Drive / Pack Profile.
For using the Pack Profile the “FSP Drive / Pack Profile” has to be enabled in the JVL Ser-
cos
®
module. This is factory default setting, but if not enabled already, then check the
“FSP Drive / Pack Profile” in the Sercos
®
tab in Mactalk, and press the “Apply and save”
button. Please refer to the picture below. For connecting MacTalk to the motor
please
see “Connect to MacTalk” on page 182.
To Next Page
Loading...