JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors 185
8.2 Commisioning
8.2.5.2 Add MLC/XLC master to IndraWorks project
Make sure the PC with IndraWorks is connected to MLC master Ethernet port, and the
JVL motor L/A IN port is connected to the MLC master Sercos
®
port, and that all devices
are correctly powered. The PWR and the L/A IN LED’s should be on.
Start IndraWorks with an empty project.
Drag and drop the appropriate master from “library / Drive and control” to the project
in “Project explorer”.
Key in the device name you want to use and press “Next”
To Next Page
Loading...