JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors 259
12.1 Technical Data
12.1.3 Powerlink for MAC or MIS - Technical specifications
Galvanic isolated, 100MBit, half duplex, 100Base-Tx, no termination necessary.
Network topology: Line and tree possibly (line recommended)
Pass through delay: <0.5μs.
Acyclic data tramsfer: SDO Upload/Download
Functions: SDO over ASND and UDP
Ethernet Powerlink version: V2
Max. 100 m cable between slaves.
Maximum number of slaves (CN’s) per segment: 239
Connectors (only applicable to MAC00-ELx):
• “PWR” (power) M12 connector 5pin male
• “I/O” M12 connector 8pin female
• “L/A IN” and “L/A OUT” (Ethernet) M12 connector 4pin D-coded female.
Supply (only applicable to MAC00-ELx):
Supply voltage (CV): 12-48VDC Nominal (absolute max. 50V)
Current rating @ 24V DC (CV): typical 150mA, max. 250mA
User I/O (only applicable to MAC00-ELx):
Input impedance: 4.7k
Input current @24V: 5.1mA
Digital output current (HW rev. Up to 1.2): 10mA
Digital output current (HW rev. from 1.3): 15mA
To Next Page
Loading...