JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors 41
3.3 Commisioning
3.3.2 Quick start with TwinCAT (JVL Profile).
1. Copy the Ethernet slave information file (“JVL ECS V14.XML”) to the folder
“..\Twincat\IO\Ethernet\” on the master PC.
2. Apply power, and make sure the PWR (power) LED is lit.
3. Connect the Ethernet cable from Master to the L/A IN connector at the MAC mod-
ule or CN2 at the MIS/MILxxxxxxECxx motor.
Check that the corresponding LED is lit.
4. Start TwinCAT - system manager on the master, and make sure that a proper Ether-
net I/O device is appended (consult your TwinCAT manual).
5. Right click the I/O device, and select "scan boxes".
Continued next page
To Next Page
Loading...