54 JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors
3.5 CiA® DSP-402 drive profile
3.5.3 Supported objects
Most of the DSP402 parameters start up in the module with default values. A few of them
are set depending on the motor type the module is mounted in - either the MAC50-141,
MAC400+ or the MIS/MILxxxxxxECxx motor.
None of the parameters can be saved to flash in the module. The following table shows
the additional object dictionary defined for DSP-402 support.
Continued next page
To Next Page
Loading...