98 JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors
4.4 Commissioning
Find and select the “Generic Ethernet module”.
Now the module parameter needs to be entered.
Fill in the information as illustrated below:
The IP-address illustrated is the factory default and may be changed according to the lo-
cal settings.
After pressing “Ok” the JVL motor is added to the project and can now be reached by
the PLC.
A demonstration video showing how to set-up the system can be seen using
this link: http://www.jvl.dk
!
To Next Page
Loading...