Commissioning User manual
26 k1evo809en-2014-04 Kaba programmer 1460
5.8 Firmware update for V3 actuators
5.9 Crossgrade for LEGIC advant components
It is possible to use a downgrade to make Kaba elolegic
components from E300 stand-alone components.
These components can therefore be used as Kaba elo-
legic N-line (N300), T-line (T300) or U-line (U300). A lat-
er upgrade back to E300 is also possible.
The Programmer 1460 and the Programmer
1364 are needed for the V3 firmware update.
1. Connect the Programmer 1364 and the actua-
tor with the programming cable.
2. Export the configuration from the actuator
with the Programmer 1364.
3. Start actuator in bootloader. (See Chapter
5.9.2.)
4. Connect the Programmer 1460 to the actua-
tor.
5. Open settings menu. (See Chapter 5.2.)
6. Select Firmware Update in the submenu and
confirm using the ENTER key.
All firmware versions that correspond to the
actuator type connected are displayed on the
Programmer.
7. Select firmware version E300 V4 (this is essen-
tial) and confirm using the ENTER key.
The firmware is transferred to the actuator.
8. Perform a downgrade. (See Chapter 5.9.1.)
9. Use the Programmer 1364 to transfer the con-
figuration to the actuator.
Check the Programmer's firmware version be-
fore the actuators' firmware update and up-
date the firmware if required.
To Next Page
Loading...