Kaba 1460 - INI Reset

Commissioning User manual
22 k1evo809en-2014-04 Kaba programmer 1460
5.4.5 TouchGo selectivity
5.4.6 INI reset
5.5 Data settings
The saved data on the Programmer is described below.
Selectivity can be set according to
requirements. The selectivity can therefore be
reduced in an environment free of problems,
or to improve reading properties, the
selectivity can be increased.
The menu is only displayed on the
Programmer if TouchGo actuators are
recognised.
1. Connect the Programmer and the actuator
(E110) using the programming cable.
2. Open settings menu. (See Chapter 5.2.)
3. Log in to the actuator using Programming
master.
4. Select Actuator, TouchGo Selectivity in the
submenu and confirm using the ENTER key.
5. Select selectivity from values 1-6 and confirm
using the ENTER key.
Note: Value 1 corresponds to the lowest selec-
tivity.
1. Open settings menu. (See Chapter 5.2.)
2. Log in to the actuator using Programming
master.
3. Select INI reset in the submenu and confirm
using the ENTER key.
4. Select yes.
INI reset is performed.