Kaba 1460 - Page 29

User manual Commissioning
Kaba programmer 1460 k1evo809en-2014-04 29
5.9.3 Overview of the INI reset actuator variants
The INI reset variants and differences for E300 (V4) and
V3 are shown in the following table.
Some actuators have INI reset contacts. To perform an
INI reset, short-circuit these contacts with electrically
conductive tweezers for approx. 3 seconds.
5. Select Firmware Version and confirm using
the ENTER key.
An upgrade is performed.
6. Following the upgrade of the remote reader
or compact reader, turn the DIP switches 5
and 6 OFF. Note: Always interrupt the current
during switching.
Actuators
Admin
Master
Programmer
1460
1; 4
Tweezers DIP switches
c-lever  x
c-lever compact 

2
x
Digital cylinder 

2
x
Remote reader  x

3
Compact reader  x

3
Key:
1
Present master medium to the Programmer
2
Present master medium or authorised user medium
(Difference: Before the INI reset for V4 or during the INI reset for V3.)
3
Turn DIP switch 6 ON
4
Not for V3 actuators