User manual Programming
Kaba programmer 1460 k1evo809en-2014-04 37
Explanation of the values:
The SNR value indicates the signal quality received
from the TouchGo transponder. A sufficiently high sig-
nal quality is essential for TouchGo to function fully.
The RSSI value displays the total signal strength re-
ceived. High RSSI values indicate sources of interfer-
ence in the immediate vicinity and reduce the
functionality of TouchGo.
During measurement of the signal strength, a
TouchGo medium must be carried in the (front)
trouser pocket and the door handle must be touched
with a hand, in order to close the signal path. Remove
the programming cable during the measurement.
Symbols Causes
No signal is received.
• Significant interference.
• The transponder is not
available or defective.
• The door handle is not
touched or faulty instal-
lation.
Increased interference in the environment.
• Increased interference
present in the environ-
ment.
•The transponder is car-
ried incorrectly.
A weak signal is received.
• Faulty installation.
•The transponder is car-
ried incorrectly or its bat-
tery is depleting.
• Possible restrictions
due to buildings.
TouchGo use is possible without restriction.
To Next Page
Loading...