Programming User manual
36 k1evo809en-2014-04 Kaba programmer 1460
6.3.3 Info for TouchGo actuators (signal strength)
1. Press Import menu key.
2. Select Info menu and confirm using the
ENTER key.
3. Connect Programmer to TouchGo actuator.
4. Navigate to the UID, SNR and RSSI points in
the menu using the DOWN navigation key.
5. Press the middle menu key and touch the
door handle, the measurement starts.
The menu is only displayed on the
Programmer if TouchGo actuators are
recognised.
To Next Page
Loading...
