25
Required User Level: Master, Manager
1. Put the lock into Pushbutton Programming Mode.
2. Enter Command 399# to activate / de-activate Passage Mode.
3. Enter the code where 1 = activate Passage Mode and 0 = de-activate
Passage Mode.
4. Example of Complete Entry to activate Passage Mode 399#1#.
5. Enter another # to indicate the end of programming.
6. You have now activated Passage Mode on the door.
7. Example of complete Entry to de-activate passage mode 399#0##,
anytime before the passage mode expiry time.
PROCEDURE 13 - DE-ACTIVATE USER ACCESS CODES
A User Code should be de-activated during a User’s vacation, for example. User
codes that are inactive, but might be needed some time in the future, should be
de-activated rather than deleted.
Required User Level: Master, Manager
1. Put the lock into Pushbutton Programming Mode.
2. Enter Command 400# to de-activate User Access Codes.
3. Enter the code 400 #NNN #, where NNN is the specific User ID
location, 023 for example.
4. Example of complete entry: 400 #023#.
5. Enter another # to indicate the end of programming.
6. You have now de-activated the User Access Code assigned to 023.
PROCEDURE 14 - DE-ACTIVATE MANAGER ACCESS
CODES
A Manager Access Code should be de-activated for a certain time period - dur-
ing a Manager’s vacation, for example. Manager Codes that might be needed
some time in the future should be de-activated rather than deleted.
Required User Level: Master
1. Put the lock into Pushbutton Programming Mode.
2. Enter Command 401# to de-activate a Manager Access Code.
3. Enter the code 401#NNN#, where NNN is the specific Manager ID
location, 024 for example.
4. Example of complete entry: 401#024#.
5. Enter another # to indicate the end of programming.
6. You have now de-activated a Manager Access Code.
To Next Page
Loading...
