15
Procedure 1 Add / Modify a User Access Code
• When users no longer need access to the lock, delete the
User Code. This permits you to use the number for a new user.
• If you only de-activate the old code, you cannot add a user
with the same number. De-activate should only be used when
the User is, for example, on vacation, and his number will be
re-activated when he returns.
• A User ID location is a 3-digit number assigned by the Master
or Manager. You should have the list of User ID locations
with you when programming locks. You should always
maintain an accurate and correct list of User ID locations and
users assigned to those ID locations.
Required User Level: Master, Manager
1. Put the lock into Pushbutton Programming Mode.
2. Enter command 100# to add / modify a User Access Code.
3. Enter the ID location followed by # - NNN#, we use 023# for
example (Range = 000 to 099). The chart on page 30 may
be helpful.
4. Enter UUUUUUUU#, representing a User Access Code of
between 4 and 8 numbers, depending on the length of Access
Code that you selected in Procedure 1 on page 7. For example,
if your code length is 8 digits, the number could be 00001024#.
5. Enter the code 00001024# again.
6. Example of Complete Entry: 100#023#00001024#00001024#.
7. Enter another # to indicate the end of programming.
8. In this example, the User Access Code 00001024 will now work
in that door with all the access privileges assigned to that
regular User.
To Next Page
Loading...
Need help?
General