To Next Page

To Previous Page

Reset Procedures

There are three different “Reset” levels available in the E-Plex 5000.

Code 099# will reset the lock to the factory default settings except

for the access code length (Master, Manager Access User codes

and Time / Date are retained if already programmed)

Code 299# will delete all access and service user codes (Master,

Manager and M-Unit * users are retained)

Hard Reset will return the lock to factory mode including deleting all

codes, putting the lock back to factory default values (4 digit access

code length) and making the master code 1-2-3-4-5-6-7-8. A hard

reset is performed as follows.

Insert key, turn and hold in open position.

Within 5 seconds, press # and then release latch

While red / green light flashes, press 1-2-3-4-5-6-7-8-# on keypad

The lock will reset. A green light with corresponding high pitch tone

indicates reset is complete.

Lock is now reset to the factory mode and the Master Code is now

1-2-3-4-5-6-7-8.

*M-Unit is only applicable when using optional E-Plex software.

Procedure 1 - Program the Access Code Length

Setting the length of Access Codes must be the first lock programmable

function you perform, because all your other access codes must have

the same length. If a user enters a code of a different length, the lock

will not accept it. Longer length Access Codes permit a greater number

of code possibilities, and thus higher security. The master code must

always be 8 digits

Required User Level: Master

1. To configure the E-Plex 5000 programmable pushbutton lock,

it must first be placed in Programming Mode.

Important: This is the only programmable function that

can be done during the factory mode using the factory

master code. Except for changing from the factory code to a

new master code.

Kaba E-Plex 5000 User Manual

Questions and Answers: