EasyManua.ls Logo

Kaba E-Plex 5000 - Summary of Pushbutton Programming Commands - Configuration; Configure Commands

Kaba E-Plex 5000
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22
Procedure 13 - De-activate User Access Codes
A User Code should be de-activated during a User’s vacation, for example,
or if you created an Access Code but never assigned it to a User. User
codes that are inactive, but might be needed some time in the future,
should be de-activated rather than deleted.
Required User Level: Master, Manager
1. Put the lock into Pushbutton Programming Mode.
2. Enter Command 400# to de-activate User Access Codes.
3. Enter the code 400 #NNN #, where NNN is the specific User ID
location, 023 for example.
4. Example of complete entry: 400 #023#.
5. Enter another # to indicate the end of programming.
6. You have now de-activated the User Access Code.
Procedure 14 - De-activate Manager Access Codes
A Manager Access Code should be de-activated for a certain time period
- during a Manager’s vacation, for example, or if you created an Access
Code but never assigned it to a Manager. Manager Codes that might be
needed some time in the future should be de-activated rather than deleted.
Required User Level: Master
1. Put the lock into Pushbutton Programming Mode.
2. Enter Command 401# to de-activate a Manager Access Code.
3. Enter the code 401#NNN#, where NNN is the specific Manager
ID location, 024 for example.
4. Example of complete entry: 401#024#.
5. Enter another # to indicate the end of programming.
6. You have now de-activated a Manager Access Code.

Table of Contents

Related product manuals