EasyManua.ls Logo

Kaba E-Plex 5000 - Summary of Pushbutton Programming Commands - User Management; Add;Modify User Commands; Delete User Commands

Kaba E-Plex 5000
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23
Procedure 15 - De-activate Service User Access Code
A Service User Access Code should be de-activated for a certain time
period - during a Service User’s absence, for example, or if you created
an Access Code but have not yet assigned it to a Service User. A
Service User’s time period continues to decrement if the User has only
been de-activated, not deleted.
Required User Level: Master, Manager
1. Put the lock into Pushbutton Programming Mode.
2. Enter Command 402# to de-activate a Service User Access Code.
3. Enter the code 402#NNN#, where NNN is the specific Manager
ID location, 024 for example.
4. Example of Complete Entry: 402#025#.
5. Enter another # to indicate the end of programming.
6. You have now de-activated a Service User Access Code.
Procedure 16 - De-activate all Access Codes except Master,
Manager, M-Unit
You may need to de-activate all users, for example, during a plant shut-
down. This procedure will de-activate all regular User Access Codes
that are active, excluding Master, Manager, and M-Unit Codes.
Required User Level: Master, Manager
1. Put the lock into Pushbutton Programming Mode.
2. Enter Command 498# to de-activate all Access and
Service Codes.
3. Example of Complete Entry: 498#.
4. Enter another # to indicate the end of programming.
5. You have now de-activated all regular User Access Codes.

Table of Contents

Related product manuals