21
Procedure 11 - Activate All User Access Codes
You may need to activate all users if you have de-activated the whole
group - after a lockout, for example. This procedure will re-activate all
regular and Service User Access Codes that are not active.
Required User Level: Master, Manager
1. Put the lock into Pushbutton Programming Mode.
2. Enter Command 398#.
3. Example of Complete Entry: 398#.
4. Enter another # to indicate the end of programming.
5. You have now activated all regular User and Service User
Access Codes.
Procedure 12 - Activate / De-activate Passage Mode
You have already programmed a default duration for a door to remain in
Passage Mode. When you enable Passage Mode, it becomes enabled
for the duration you have set in Procedure 5 - Program the Duration of
the Passage Mode period, on page 10.
If your length is 6 hours, and you enable Passage Mode at 1:00, it will
automatically re-lock at 7:00. Even if the lock was taken in and out of
Passage Mode multiple times during the six hour period, it will still re-lock
after six hours (programmable) from the original starting period. This
ensures that a lock will never remain in Passage Mode beyond the
programmed time period.
Required User Level: Master, Manager
1. Put the lock into Pushbutton Programming Mode.
2. Enter Command 399# to activate / de-activate Passage Mode.
3. Enter the code where 1 = activate Passage
Mode and 0 = de-activate Passage Mode.
4. Example of Complete Entry to activate Passage Mode 399#1#.
5. Enter another # to indicate the end of programming.
6. You have now activated Passage Mode on the door.
To Next Page
Loading...
