Kaba Saflok SYSTEM 6000 - Page 118

System6000
TM
ReferenceManual_Section6
© SAFLOK Page19of34 06/11
6.7TypesofKeycards(continued)

ProgramInformationKeycards(PI)
ProgramInformationkeycardsareusedtoprogramallofthelockinformation,includinglockname,dateandtime,
DST,autolatch,levelprogramming,keymastering,etc.ThesekeycardsmustbeusedwithaPPK.

ProgramStatusChangeKeycards(PS)
ProgramStatusChangekeycardsareusedtochangethestatusofalock.TheyincludetheLEDDiagnosticskeycard,
theE2Erasekeycard,theE2Disable/EnablekeycardandtheBatteryDisconnectkeycard.TheStatuskeycards
mustbeusedwithaPrimaryProgramkeycard(orSecondaryProgramkeycardifthePPKisnotavailable.)


StandardKeycards
StandardkeycardsallowchangestoaStandardKeycardthatisalreadystoredinthelock’smemory.Theyinclude
theResequenceKeycard,theInhibit‐A‐keycardandtheUninhibit‐Akeycard.TheResequencekeycardisusedto
bringthelock’scurrentkeycardsequenceinformationintoagreementwiththecomputer’skeycardsequence
informationforthatkeycard.TheInhibit‐A‐keycardandtheUninhibit‐A‐keycardaffectonlytheStandardKeycard
theyweremadetoeffect.

DisplayKeycards
DisplaykeycardsenableyoutodisplaythefollowinglockinformationbywayoftheLED’s:

1. EPROMVersion(Lock’sProgramVersion)
2. ClockTime
3. ClockDate
4. AutolatchStatus
5. LastTwoLPIRecords
6. KnobTurnSwitch
7. DeadBoltSwitchStatus
8. MotorSwitchStatus
9. LowBatteryLife
10. ClockRunTest
11. LEDLightsTest

StarterKeycards
StarterKeycardsareprovidedatthetimeofinstallationandconsistoftenkeycardsthatcanbeusedinlieuofthe
LPITerminaltoprogramalocksothatitwillacceptInstaller’sorNewConstructionkeycards.Thelockwilllater
needtobeprogrammedbywayoftheLPIbeforeitwillacceptkeysmadeformtheproperty’scomputer.