Relay controlled output:
KT-1-PCB
2 onboard form C relays, 30 VDC/VAC, 3 Amps each, 0.6
power factor
Communication ports:
KT-1
2 x RS-485, 1 x Ethernet 10/100 Base-T with RJ-45
Communication ports:
KT-1-PCB
1 x RS-232 with RJ-12, 2 x RS-485, 1 x Ethernet 10/100 Base-
T with RJ-45.
Note: RS-232 is for supplementary use.
Auxiliary power 1.0 A max (shared with door strike power)
Communication speed
- 1200 to 115200 Bauds (automatic detection) over RS-485 -
10/100 Mb/s BaseT over Ethernet
Flash memory
256 MB NAND flash for application, storage and stand-alone
event buffer holding 20,000 events
RAM memory 128 MB DDR2 for application loading and running
Network autonomy Distributed data and processing
Certifications / Listing
USA: UL294, UL1076, FCC Part 15 Class B Canada: ICES-003
(B)/NMB-003 (B) Europe: EN60950-1, EN50130-4:2011,
EN61000-6-3. CE Compliance in accordance with applicable
LVD and EMC Directives. Australia/New Zealand: RCM Com-
pliance
AES Encryption AES NIST Validation of certificate No. 3092
*Note: The KT-1 has been tested by UL with the PoE/PoE+ modles Phihong
POE36U-1AT-R and/or the POE125U-4-HP-R. These devices shall be used in con-
junction with UL listed Transient protectors. Other compatible PoE/PoE+ con-
figurations may be possible.
**Note: The KT-1 is capable of restarting automatically after total power loss, and
will keep the programming for an unlimited time of power interruption. The design
uses flash memory for saving access rules. For KT-1 and Class B installations
powered with a PoE device, it is recommended to use a ferrite on the Ethernet
cable. (P/N 10000089).
©Copyright, 2016, all rights reserved
26
To Next Page
Loading...
Need help?
General
