KaVo ABSORmatic plus - 9.21 Inserting active carbon filter

9.21 Inserting active carbon filter .
Remove waste container  as described in
9.20 Lift up the two snap-locks on the
hood  over the sound absorbent linings or
drawers for active carbon filters respective-
ly and remove the hood .
Remove the two sound absorbent linings 
or used active carbon filter blocks .
(Monitoring and duration of use settable,
see 9.12-9.13 User help program)
Insert new active carbon blocks  (qty. 2)
so that the seal is towards the outer side.
Fit the hood  (bevel towards the front),
press on and lock with the two snap-locks.
Carry out further installation as described
in 9.20.
On removal of active carbon filters
which are no longer effective, a reset
must be performed according to user help
program 9.15 after installation of new
active carbon filters.
At the same time, the “change time“ can be
adapted to the requirements ranging from
100 to 2500 operating hours (see user pro-
gram 9.13).
27
ABSORmatic
®
plus.
A
B
S
O
R
m
a
t
i
c
®
A
B
S
O
R
m
a
t
i
c
®
A
B
S
O
R
m
a
t
i
c
®
A
B
S
O
R
m
a
t
i
c
®
Í



