KaVo ABSORmatic plus - 10.3 LED-Display operating mode Waste container lights up; 10.4 Filter change (if filter is damaged or several filter cleanings without succes).

10.3 LED-Display operating mode
“Waste container“ | light's up
(see operating faults 11.8 Warning 31 - fill-
ing level of waste container 1201).
Continuous lighting of the red LED “Waste
container“  operating mode indication
signals “Waste container full“. On the next
occasion when the suction motor is turned
off, it will be stopped automatically and
prevented from starting up. The waste con-
tainer  must now be removed and emp-
tied before work can be continued.
Take off the front panel  and withdraw
the stainless steel slide  under the waste
container . Press down the locking lever
 of the waste container.
Insert the stainless steel slide  above the
container in the “upper parking position“ in
the groove provided (must come flush
against the seal). Remove waste container
 and remove excess material of the waste
bag from the double edge. Close the dust-
filled waste bag  by means of a cable tie.
Take out the waste bag  filled with dust
and dispose of it.
Place new waste bag  in the cleaned
waste container  and press it against the
base and sides of the container. Lay the
protruding material in the double edge of
the container. Press the waste bag 
against the contours of the waste container
to keep trapped air to a minimum. Place
cardboard insert (accessory disposal set) at
the bottom of the container and clamp.
Reinsert waste container  with waste bag
 into the dust collector. Withdraw the
stainless steel slide  while pressing it
upwards against the rubber seal, and refix
the waste container by pressing the locking
lever  upwards. Insert the stainless steel
slide , after cleaning under running
water, into the lower parking position¡
(under waste container ).
Refit the front panel .
Flashing of the operating mode “Waste
container“ LED  (see operating faults
11.2 "Error" 11 - wast container 1200) indi-
cates that there is no waste container in the
dust collector and all functions are blocked.
10.4 Filter change (if filter is damaged or
several "filter cleanings" without suc-
ces).
(see operating faults 11.4 Warning 24
1200)
29
ABSORmatic
®
plus.
A
B
S
O
R
m
a
t
i
c
®
A
B
S
O
R
m
a
t
i
c
®
A
B
S
O
R
m
a
t
i
c
®
A
B
S
O
R
m
a
t
i
c
®
ABSORmatic
®
A
B
S
O
R
m
a
t
i
c
®
A
B
S
O
R
m
a
t
i
c
®
ABSORmatic
®
|
Í
Í

Í
#


|