2 Setup methods according to DIN EN ISO 17664
2.1 References
The reprocessing consists of the following basic steps:
▪ Cleaning and disinfection ( manually or automatically)
▪ Sterilisation
Note
Comply with national hygiene requirements, e.g. RKI guidelines.
CAUTION
Risk of injury during cleaning of the treatment unit.
Lack of instructions to the cleaning staff and lack of preparation of the treatment
unit can lead to the cleaning personnel sustaining injuries.
▶ Only trained professionals and instructed cleaning personnel may be present
in the treatment rooms.
▶ Position the chair for cleaning and turn the device off.
CAUTION
Product damage due to improper disinfection.
Malfunctions.
▶ Use disinfectant in accordance with the instructions of the manufacturer.
▶ No spray disinfection, perform wipe disinfection only.
▶ Do not immerse product or product parts in liquids.
CAUTION
Improper disinfection may lead to health hazards and material damage.
Infection hazard to users and patients.
Damage to the sterile product.
▶ No hot air sterilisation, no chemical cold sterilisation, do not sterilise with eth‐
ylene oxide.
Note
The preparation methods for the instruments and motors are found in the separate
instructions for use that accompany the instrument and motor packages.
2.2 General instructions for the reprocessing of KaVo treatment units
Please comply with the general reprocessing instructions at all times. Detailed prod‐
uct-specific reprocessing instructions are provided subsequently.
At the site of use ▶ Remove surface contamination using a disposable cloth/paper towel.
Storage and transport KaVo recommends reprocessing as soon as possible after use.
Care instructions ESTETICA E50
2 Setup methods according to DIN EN ISO 17664 | 2.1 References
3/32
To Next Page
Loading...
