Kaypro 10 - Page 129

10. To skip FILEB.DAT, type N again. If the next MUFBAR file in sequence is
on the NEXT disk , you will see ...
B:MUFBAR .003 cannot be found on this disk.
Insert next source disk and type drive name (A - P) __
This means that the next MUFBAR file in sequence is not on this disk.
11. Remove the floppy disk, and replace it with the next one.
12. Type the drive letter .
Press RETURN.
Eventually we come to FILEC.DAT which is what we want.
13. Answer the prompt by typing Y. You will see ...
Opening file - B:MUFBAR .005
A:FILEC .DAT already exists. Remove it? (YIN) Y
Removed current file.
Restoring new - A:FILEC .DAT
The cur rent file which is removed is the file which existed when you began
the restoration. The new file is from the floppy disk .
If you get the message, ERROR CANNOT REMOVE FILE. RESTORE
ABORTED, you have attempted to restore a write-protected file or disk,
If you get the message, ERROR DIRECTORY FULL, the destination drive
(hard disk) is full. You must remove some files and re-run MUFREST.
If you get the message, ERROR IN HEADER RECORD. RESTORE
ABORTED, the header record of a MUFBAR file does not match the header
record of MUFBAR.001 . You have inserted the wrong disk. Re-start the
restoration with the proper disks.
If you get the message, CANNOT OPEN OUTPUT FILE. RESTORE
ABORTED, the dest ination drive is write-protected. You must change its
status and re-run MUFREST.
If you get the message, ERROR IN WRITING OUTPUT FILE. RESTORE
ABORTED, you have a system I/O error or are out of space.
91