Kaypro 10 - STARTING YOUR KAYPRO 10

STARTING YOUR KAYPRO 10
1 .. Turn on the computer, using the power sw i tch on the back panel. Wait 15-20
seconds while the hard disk within the computer rotates up to speed.
The
disk unit runs with the read/write head in contact with
the disk at all times. When the computer is not "busy " , the
head is moved into a safety zone on the disk, and the red
light on the right goes off.
2. Wait for the ready light on the right to go off.
POWER ON
25
10 MB READY LIGHT
DRIVE INDICATOR
LIGHT