KB Electronics KBDA-24D User Manual

24
FIGURE 17 – FLOW CHART TO PROGRAM MOTOR CURRENT FROM 6.7 AMPS TO 5.5 AMPS
*For Models KBDA-27D, 29, the factory setting of Motor Nameplate Current (Function No. 0.01) is 6.7 Amps. See Table 3, on page 10, for the
factory setting of Function No. 0.01 for all other models.
("FWD", "STOP", "Hz" LEDs On)
Set Frequency Flashes Group No.
Digit Flashes
("PGM" LED On)
Press Program Key
Function No.
to Display
POWER ON
which Confirms Programming
"End" Momentarily Displays
Digit Flashes
Motor Nameplate Current
Code No.
to Return
to Set Frequency Display
Press Display Key
Digit Flashes
Motor Nameplate Current
Press Shift Key 1 Time
to Move Digit
Motor Nameplate Current
Digit Flashes
to Move Digit
Press Shift Key 2 Times
to Increase Digit
Press Up Key 1 TimeCode No.
Digit Flashes
Code No.
Motor Nameplate Current
Motor Nameplate Current
Press Read Key
to Read
Digit Flashes
Digit Flashes
Motor Nameplate Current *
Press Shift Key 1 Time
to Move Digit
Motor Nameplate Current
Digit Flashes
Press Down Key 2 Times
to Decrease Digit
Press Down Key 1 Time
to Decrease Digit
Motor Nameplate Current
Digit Flashes
to Save New
Press Enter Key
Motor Nameplate Current

KB Electronics KBDA-24D Specifications

General

Brand	KB Electronics
Model	KBDA-24D
Category	Controller
Language	English