KEB COMBIVERT R6-N User Manual

DeneCP-Parameters
© KEB, 2015-07 COMBIVERT R6-N Page3.9 - 7
3
10
3.9.4Deneownstandardizations
default
ud.19 multiplier
± 32767
ud.20 offset
± 32767
ud.18 divisor
± 32767
ud.21 ctrl. displaynorm
0...1791
CP.xx = (selected parameter + ud.20) x ud.19 x Unit
ud.18
ud.19 multiplier
± 32767
ud.20 offset
± 32767
ud.18 divisor
± 32767
CP.xx = ud.19 x unit
(selected parameter + ud.20) x ud.18
inverted
For the "selected parameter" either "non-standardized value" or "standardized value/resolution" is used !
ud.18 Divisor display standardization
Adjusts the divisor in the range of ±32767 (default 1). The parameter is set-programmable.
ud.19 Multiplier display standardization
Adjusts the multiplier in the range of ±32767 (default 1). The parameter is set-programmable.
ud.20 Offset display standardization
Adjusts the offset in the range of ±32767 (default 0). The parameter is set-programmable.
ud.21 Display standardization Mode
ud.21 adjusts the calculation mode, decimal places as well as the displayed unity in KEB COMBIVIS. The pa-
rameter is bit-coded and set-programmable. The parameter can be adjusted in the range of 0...1791.
Bit 12...15 Bit 11...8 Bit 7...6 Bit 5...0 ud.21

KEB COMBIVERT R6-N Specifications

General

Brand	KEB
Model	COMBIVERT R6-N
Category	Inverter
Language	English