KEB COMBIVERT R6-N User Manual

Page 4.2 - 4 COMBIVERT R6-N © KEB, 2015-07
Start-up
cS.03 mains frequency max. tolerance
If the current mains frequency deviates to the adjusted percentage value of the recognized line frequency
(ru.03), error message „E.FnEt“ is displayed. A change of the default value is not necessary.
The parameter is preset with Pn.19.
Deactivate regeneration
cS.05 Puls off delay, cS.06 puls off level (CP.32)
Iftheactualpower(ru.81/CP.13)exceedsthedenedvalueincS.06(CP.32),themodulationisswitchedoff
after expiration of the adjusted time in cS.05.
The parameter settings can usually be left at the default settings!
4.2.2 R6 operation only as regenerative unit
Generally also for operating mode regeneration all relevant parameters of the regenerative unit are preset
whenusingaR6unitandKEBcommutationchokeorharmoniclterbasedondefault values, power unit code
and the operating mode Pn.19 (CP.33).
Deactivate regeneration
cS.05 Puls off delay, cS.06 puls off level (CP.32)
Iftheactualpower(ru.81/CP.13)exceedsthedenedvalueincS.06(CP.32),themodulationisswitchedoff
after expiration of the adjusted time in cS.05.

KEB COMBIVERT R6-N Specifications

General

Brand	KEB
Model	COMBIVERT R6-N
Category	Inverter
Language	English