30
~-
NOTES ON MAINTENANCE
Tyre
profile
Checking the tyre profiles
&,.
WARNING
Observe the minimum profile depth pre-
scribed by law.
Never ride without valve caps(1) . Firmly
tightened valve caps prevent the tyre fr-
om suddenly losing pressure.
- Measure the profile depth at the centre (2)
of the tyre•s tread.
Recommended minimum profile depth:
2.0mm
Observe the wear marks(3).
__,,,..
Checking
the
tyre pressu
re
&. WARNING
Adjust the tyre pressure according
tot-
he total weight load. Never exceed the r-
ated total weight or the bearing capacity
of the tyres.
Incorrect tyre pressure will have a consi-
derable effect on the riding properties of
the scooter and the lifespan
of
the tyres.
- While the tyres are cold:
- Twist off the valve caps.
-
Check/
adjust the tyre pressure.
- Twist
on
the valve caps.
Tyre pressure
One
Rider:
Front: 1.75Kg/cm
2
Rear: 2.00Kg/cm
2
Two Rider:
Front:
2.00Kglcm'
Rear:
2.25Kglcm
'
Tyre size
The standard scooter
is
provided with the
following ty
re
sizes:
Front 110/70-13 M/C 48S
or
55L
Rear 130/70-13 M/C 57S or 63S
or
63P
All
Tyres are tubeless.
&,
WARNING
Use only tyres approved by the manufa-
cturer. The use
of
non-approved tyre br-
ands, types or sizes leads
to
the operati-
ng permit
of
the vehicle becoming null a-
nd void.Use only pairs of tyres produced
by the
same
manufacturer.
Front wheel brake
&,
WARNING
Sudden
changes
in
play
or
a
spong
y feel
of
the
brake
lever (1) can
be
caused
by
faults
in
the
hydraulic
system.
Do
not
ride
on when
in
doubt
about
the
operability
of
the
brake
system.
Immedi-
ately
consult
a dealer.
,-.
~~-"
Front
brake-fl
ui
d
tank
Checking
the
brake-fluid
l
evel
&,
WARNING
Every
two
years,
the
brake
fluid
m
ust
be
changed by a dealer. The level must not
drop below the MIN mark.Use only brake
fluid of the DOT 4 classification.
CAUTION
Do not spill any brake fluid on painted or
plastic surfaces as It will demage the su•
rface severely.
NOTES ON
MA
INTENANCE
• Turn the handlebars until the brake-fluid t·
ank
(2)
is level.
• The brake fluid level(3)should be between
the minimun (MIN) and the maximum mar-
king (MAX).
• II air bubbles can be seen.check the brake
linings for wear; if necessary, replenish the
brake fluid by a dealer.
,·
\ {
};,.,
\
31
To Next Page
Loading...
