Keithley 2000 - Page 54

51
SuffixY0
Y1
Disable output suffix
(default)
Enable output suffix
Terminator W0
W1
W2
W3
W4
W5
W6
W7
Enable CR LF EOI (default)
Enable CR LF only
Enable CR EOI only
Enable CR only
Enable LF EOI only
Enable LF only
Enable EOI only
Disable all output termina-
tors
Clear *
X0
Device clear (resets 8842A
to default conditions)
Clear error register
Single-trigger ? Trigger measurement
GET G0
G1
G2
G3
G4
G5
G6
G7
G8
G9
Get instrument configura-
tion (function, range,
speed, trigger)
Get SRQ mask
Get calibration input
prompt (generates error
message 51)
Get user-defined message
(replies with 16 space
characters)
Get calibration status
(replies with “1000”)
Get IAB status (input F/R,
autorange on/off, offset on/
off)
Get YW status (suffix
enabled/disabled, termina-
tor selection)
Get error status
Get instrument ID
(replies with
“FLUKE,8842A,0,EMUL”)
Get status of JKM com-
mands (temp. units; TC
type and junction)
String = 1jkm
Table 17. Models 8840A/8842A device-dependent
command summary (cont.)
Mode Command Description
2000-903-01A Page 51 Thursday, December 23, 1999 7:52 AM