Keithley 2002

To Next Page

To Previous Page

2.10 Low-level calibration......................................................................................................................................... 2-13

2.10.1 Recommended equipment for low-level calibration ................................................................................. 2-13

2.10.2 Low-level calibration summary................................................................................................................. 2-13

2.10.3 Front panel low-level calibration procedure.............................................................................................. 2-16

2.10.4 IEEE-488 bus low-level calibration procedure ......................................................................................... 2-20

2.11 Single-point calibration ..................................................................................................................................... 2-24

2.11.1 Front panel single-point calibration........................................................................................................... 2-24

2.11.2 IEEE-488 bus single-point calibration ...................................................................................................... 2-24

3 Calibration Command Reference

3.1 Introduction ......................................................................................................................................................... 3-1

3.2 Commands........................................................................................................................................................... 3-1

3.2.1 Command summary..................................................................................................................................... 3-1

3.3 :CALibration:PROTected Subsystem ................................................................................................................. 3-3

3.3.1 :INIT ............................................................................................................................................................ 3-3

3.3.2 :LOCK ......................................................................................................................................................... 3-3

3.3.3 :SWITch?..................................................................................................................................................... 3-4

3.3.4 :SAVE.......................................................................................................................................................... 3-4

3.3.5 :DATA? ....................................................................................................................................................... 3-4

3.3.6 :DATE ......................................................................................................................................................... 3-5

3.3.7 :NDUE......................................................................................................................................................... 3-5

3.3.8 :DC .............................................................................................................................................................. 3-6

3.3.9 :LLEVel..................................................................................................................................................... 3-11

3.4 :CALibration:UNPRotected Subsystem............................................................................................................ 3-13

3.4.1 :ACCompensation ..................................................................................................................................... 3-13

3.5 Bus error reporting ............................................................................................................................................ 3-13

3.5.1 Calibration error summary ........................................................................................................................ 3-13

3.5.2 Detecting Calibration Errors...................................................................................................................... 3-13

3.6 Detecting calibration step completion ............................................................................................................... 3-14

3.6.1 Using the *OPC? Query ............................................................................................................................ 3-14

3.6.2 Using the *OPC command ........................................................................................................................ 3-14

3.6.3 Generating an SRQ on calibration complete ............................................................................................. 3-14

APPENDICES

A Specifications ............................................................................................................................................. A-1

B Calibration Programs.................................................................................................................................. B-1

C Calibration Messages.................................................................................................................................. C-1

D Calibration Command Summary................................................................................................................ D-1