Section 8: Troubleshooting FAQs Model 2651A High Power System SourceMeter® Instrument User's Manual
8-2 2651A-900-01 Rev. A / March 2011
• To view the IP address of the Model 2651A, press MENU. Select LAN > STATUS >
IP-ADDRESS. If a valid IP address is displayed, the instrument configuration is correct. If 0.0.0.0
is displayed, the IP address is not valid.
• If you are using the automatic configuration method over a corporate network, contact your
network administrator for assistance.
• If you are using the automatic configuration method and you have a one-to-one connection
between the instrument and the computer, verify that the computer is set to receive an IP address
automatically.
• If you are using the manual configuration method over a corporate network, verify that you have
entered the IP address, gateway, and subnet mask provided by your network administrator.
• If you are using the manual configuration method and a one-to-one connection with the computer,
verify that the subnet mask agrees with the computer's settings.
• If the above suggestions do not work, see the Model 2651A Reference Manual, "Communication
interfaces."
Save the present state of the instrument
How do I save the present state of the instrument?
You can save the present state of the instrument using the front-panel menus or from a command
interface. See the Model 2651A Reference Manual, "User setups."
LabVIEW driver for the Model 2651A
Where do I find the LabVIEW driver for the Model 2651A?
The latest NI
TM
LabVIEW
TM
driver is available from the Keithley Instruments support website
(http://www.keithley.com/support).
To Next Page
Loading...
