Kemppi Promig 530 User Manual

Promig 530 / 0612 – 23© kemPPi oy
Control of MMA dynamics:
With control of MMA dynamics you can inuence on arc in different situations.
When you make the arc harder, blow and at the same time spatter is increased.
-9...-1 Softer arc. Object: Minimizing spatter in welding at upper end of recommended currents
for electrode.
0 Factory setup. Normal setting for all electrode types.
1...9 Harder arc. Object: e.g. cellulose covered electrodes (9) and thin stainless electrodes in
welding at lower end of recommended currents for electrode.
Digital display for wire feed speed, current and voltage P31, P32, P33
/m/min display
MIG/MAG with independent controls for wire feed speed and voltage: Display shows set value
for wire feed speed and true value 0.0...18.0 m/min or 0.0...25.0 m /min during welding depending
on selection of wire feed speed range.
SYNERGIC MIG welding:
Display shows set value for wire feed speed and true value during welding.
Wire feed speed range is a wire type min. and max. speed.
SYNERGIC PULSED MIG welding:
Display shows set value for wire feed speed and true value during welding.
Wire feed speed range is a wire type min. and max. speed.
MMA weldig: Display is blank at MMA welding.
I/A display
MIG/MAG welding with independent controls for wire feed speed and voltage: Display shows in
setting state 0 A and true value during welding.
SYNERGIC MIG welding:
Display shows in setting state 0 A and true value during welding.
SYNERGIC PULSED MIG welding:
Display shows in setting state the reference mean current value and true value for welding current
during welding.
MMA welding:
Display shows set value for MMA welding current 10 A...max. current of power source and true
value during welding.
U/V display
MIG/MAG welding with independent adjustments for wire feed speed and voltage: Display shows
set value for welding voltage and true value during welding.
SYNERGIC MIG welding:
Display shows set value for welding voltage and true value during welding.
By adjustment of arc length in display is shown adjustment value -9...0...9 for arc length, which
is kept in display still for 3 s after end of adjustment.
SYNERGIC PULSMIG welding:
Display shows in setting state value -9...0...9 for arc length and during welding true value of
welding voltage.
MMA welding:
Display shows in setting state open circuit voltage of power source and true value for MMA welding
voltage during welding.

Kemppi Promig 530 Specifications

General

Brand	Kemppi
Model	Promig 530
Category	Welding System
Language	English