EasyManuals Logo

Kemppi Promig 530 User Manual

Kemppi Promig 530
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
Promig 530 / 0612 – 31© kemPPi oy
7. SERVICE, OPERATION DISTURBANCES
The amount of use and the working environment should be taken into consideration when planning
the frequency of maintenance of PROMIG. Careful use and preventive maintenance will help to
ensure trouble-free operation.
The following maintenance operations should be carried out at least every six months:
Check:
The wear of the grooves of the feed rolls. Excessive wear of
grooves causes problems in wire feed.
The wear of the wire guide tubes of wire feed. Badly worn feed
rolls and wire guide tubes should be discarded.
The wire guide tube in the gun should be set as near the feed
rolls as possible, but not touching them and the wire must follow
a straight line from the end of the tube to the groove of the feed
roll.
Reel brake adjustment.
Electric connections
* Oxidized couplings must be cleaned
* Loose couplings must be tightened
Clean dust and dirt from the equipment.
When using compressed air, always protect your eyes with
proper eye protection.
In case of problems contact your KEMPPI dealer.
7.1. DISPOSAL OF THE MACHINE
Do not dispose of electrical equipment together with normal waste!
In observance of European Directive 2002/96/EC on Waste Electrical and Electronic
Equipment and its implementation in accordance with national law, electrical equipment
that has reached the end of its life must be collected separately and returned to an
environmentally compatible recycling facility. As the owner of the equipment, you should
get information on approved collection systems from our local representative.
By applying this European Directive you will improve the environment and human
health!
twice a
year

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kemppi Promig 530 and is the answer not in the manual?

Kemppi Promig 530 Specifications

General IconGeneral
BrandKemppi
ModelPromig 530
CategoryWelding System
LanguageEnglish

Related product manuals