Promig 530 / 0612 – 29© kemPPi oy
6. Automatic remote -> local switching with MC, ML and MX panel
Remote -> local switching works, when remote controller is taken away
Remote -> local switching is off
7. Hot start function with MC and ML panel
No hot start, on delivery
Hot start selected
8A. Crater lling in 4T with synergic MIG / PULSMIG, ML-panel only
8B. Selection of 2T or 4T with ”no panel”
8C. Selection of crater lling with MC panel
8D. MX-panel selecto restores U-pot. value
ML/MC-panel: No crater lling, on delivery
MX-panel selecto does not restore U-pot. value (ne control active)
2T MIG without panel
ML-panel: Crater lling in 4T with synergic PULSMIG/MIG
MC-panel: Crater lling in 4T
MX-panel selecto restores U-pot. value (no ne control)
4T MIG without panel
9A. Selection of synergic MIG / pulsed MIG, ML-panel
9B. Selection of plate thickness / amperage display, MX-panel
Fe synergic PULSMIG / MIG in ML panel, on delivery
Plate thickness display is on with MX-panel
AlSi synergic PULSMIG / MIG in ML panel instead of Fe.
Extra label needed to change Fe text to AlSi text
Amperage display is on with MX-panel
10. Selection of max wire feed speed
Max. speed 18 m/min, on delivery
Max. speed 25 m/min
To Next Page
Loading...
Need help?
General
