Kenwood DMX8520DABS User Manual

Setup
73English
5
Touch [Learning completed].
NOTE
• When changing the function already learned,
press and hold the button you want to change
in step 2 and then touch to select the changed
function from the function list.
• Confirm the contents of the settable function on
the function list. You cannot edit the function list.
• To initialize the contents, touch [Learning
initialisation] of [Steering Remote
Controller] in User Interface screen. After you
touch [Initialise], a confirmation message
appears. Follow the message and complete the
operation.
Ñ Register operations by Gesture
Control (DDX920WDABS)
You can register operations that work by the
motion of your hand.
1
Touch [Gesture SETUP] on the User
Interface screen.
 Gesture SETUP screen appears.
2
Touch a gesture mark you want to set.
■ [Initialise]
Return to the initial setting. The confirmation
message appears. Touch [Ye s ].
3
Touch the function you want to set.
4
Repeat steps 2 and 3 as necessary.
5
Touch [ ].
Special Setup
You can setup special parameters.
1
Press the [MENU] button.
 Popup menu appears.
2
Touch [SETUP].
 SETUP screen appears.
3
Touch [Special].
 Special screen appears.
4
Set each parameter as follows.
■ [DEMO]
Select the demonstration mode. Default is
“ON”.
■ [Software Information]
Confirm the software version of this unit.
(P.73)
■ [Open Source Licenses]
Display the open source licenses.
■ [Initialise]
Touch [Initialise] and then touch [Yes ] to set
all the settings to the initial default settings.
• Audio SETUP Memory is not initialized.
Ñ Software Information
You can confirm the software version of this
unit.
1
Touch [Software Information] in the
Special screen.
2
Confirm the software version.

Kenwood DMX8520DABS Specifications

General

Brand	Kenwood
Model	DMX8520DABS
Category	Car Video System
Language	English