EasyManua.ls Logo

Kenwood DMX8520DABS - Page 93

Kenwood DMX8520DABS
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Connection/Installation
93English
Ñ Microphone unit
1) Check the installation position of the
microphone (accessory 4).
2) Clean the installation surface.
3) Remove the separator of the microphone
(accessory 4), and stick the microphone to
the place shown below.
4) Wire the microphone cable up to the unit
with it secured at several positions using tape
or other desired method.
5) Adjust the direction of the microphone
(accessory 4) to the driver.
4
Fix a cable with a commercial item of tape.
Ñ Detaching the trim plate
(DDX9020DABS / DMX8520DABS /
DMX8020S)
1) Detach accessory 7 to the unit.
7
Ñ Installation the Digital Radio
antenna
(DDX9020DABS / DDX920WDABS/
DMX8520DABS)
#CAUTION
This film antenna is exclusively for use inside the
vehicle.
Do not install at the following locations:
Where it may block driver’s view
Where it may obstruct operation of safety devices
such as air bags
On movable glass surface such as rear hatch
On the side of the vehicle (e.g. doors, front-side
windows)
On rear windows
Signal strength will decrease at the following
locations:
On IR reflecting glass or where covered with mirror
type glass film
Where it overlaps with genuine radio antenna
(pattern)
Where it overlaps with window heating wires
When glass that blocks radio signals (e.g. IR
reflecting glass, thermal insulation glass) is used
Poor reception may occur:
Due to noise when the windshield wipers, air
conditioner, or motor is turned on
Depending on the location of the broadcast station
in relation to the vehicle (antenna)
Thoroughly wipe oil and dirt from the pasting surface
with the included cleaner (accessory =).
Do not bend or damage the film antenna (accessory
~).
It may not be possible to install on some type of
vehicle.
Check the cable routing of the film antenna (accessory
~) and amplifier (accessory !) before pasting.
Installation overview
The antenna should be installed on the
passenger side for safety.
~ !
Antenna cable
(3.5 m)
Determining the antenna installation
location
The direction of the film antenna (accessory ~)
changes depending on whether the film antenna is
installed on the right side or left side.
Be sure to check the installation location of the film
antenna (accessory ~) before installing. The film
antenna cannot be reattached.
Install the antenna at least 100 mm away from other
antennas.
Do not attach the amplifier unit (accessory !) to the
ceramic line (black part) around the windscreen, as it
will not stick sufficiently.

Table of Contents

Related product manuals