TCDS-BA-e-2210 32
Procedure:
1. Define target quantity and tolerances
Make sure that the scale is in counting mode and that an
average piece weight has been (see chap. 9.2.1).
If necessary, switch over with the key.
Call up menu setting < ref >.
Use the navigation keys to select the setting < check
target > and confirm with ➔ button.
< value > is displayed.
Confirm on ➔ button, the numeric input window appears.
The active digit is flashing.
Enter the target number of pieces (numerical input see
chap. 3.2.2) and confirm the entry.
The balance returns to the < value > menu.
Use the navigation buttons to select setting
<Errupp >.
Confirm on ➔ button, the numeric input window appears.
The active digit is flashing.
Enter the upper tolerance (for numerical entry see chap.
3.2.2) and confirm the entry.
The balance returns to the < Errupp > menu.
To Next Page
Loading...
