KERN CDS 4K0.02 - Check Counting

TCDS-BA-e-2210 34
9.2.7 Check counting
With the <Check counting> application you can check if the weighing good is within
a predefined tolerance range.
When limit values are exceeded below or above, an acoustic signal (if enabled in
menu) will sound and an optical signal (tolerance marks) will be displayed
Optical signal:
The tolerance marks provide the following information:
Target quantity exceeds defined tolerance
Target quantity within defined tolerance
Target quantity below defined tolerance
Acoustic signal:
The acoustic signal depends on the menu setting
< setup  beeper >, see chap. 10.3.1.