KERN EW User Manual

4.8 Calibration Of Built-In Weight (Ref Cal)
- EG Type -
• Following does not describe the procedure of ordinary span calibration.
• This is the procedure of calibration of the built-in weight with EG scales
• It is necessary to adjust the linearity of the scale beforehand. Refer to 4-7.
- 23 - EW_EW-C_EG_N-SH-e-0722

KERN EW Specifications

General

Display	LCD
Minimum part weight at piece counting (Laboratory scale)	0.1 g
Weighing plate material	stainless steel
Measuring system	Strain gauge
Interface	RS 232
Calibration	External calibration
Power Supply	AC adapter or 4xAA batteries
Units	g lb oz