5.7 How To Remove Calibration Weight Unit
5.7.1 EG 220-620
1. Remove the CN3 connector. (Removing AJDP P.C.B. in advance makes it easy to
do it.)
2. Remove (cut) the cord band.
3. Unscrew at two points.
5.7.2 EG 2200-4200
(1) Remove SW cord assy from AJDP circuit board
(2) Remove the weight holder
- 39 - EW_EW-C_EG_N-SH-e-0722
To Next Page
Loading...
