KERN PNJ Series - 7 Basic Operation; 7.1 Start-up; 7.2 Switch into stand-by mode

PNJ_PNS-BA-e-1612 29
Position seals and verification switch
Prior to verification, the verification switch must be moved into the verification
position. In this position the display shows a bracket around the last display point.
After verification the balance is sealed at the indicated positions.
Models d = 0.001g Models d = 0.01g / 0.1 g
1 Switch cover / Position verification switch
2 Self-destroying seal mark
3 Metrology mark [M]
1 2
2 3
2 3