Keyprocessor Orion - Using an Adapterboard

16
Remark: When using a shielded wire (conductive), the shield should be attached
on one side to earth (⏚) of the installation housing.
Note! The last Orion on the communication line must be provided of an EOL
jumper.
6.1.2 Using an adapterboard
When it is not possible to use a standard UTP cable between the Orion and the Network
controller, an adapter board can be used.
A direct connection (without using an adapterboard) between the Orion and a Polyx™ is NOT
possible when:
 Orion and Polyx™ are installed in different buildings and thus the connection
leaves the building or
 the wiring is no UTP cable (CAT5 or CAT6) or
 an existing (non UTP) cable is reused or
 overvoltage protection is required
Standard UTP CAT5 is used between an adapterboard and Polyx™
RS485 bus
UTP CAT 5
I
I
max. 8 per bus
Example: 2
I
I
RS485 bus
max. 8 per bus
L
L