Keyprocessor Orion User Manual

20
7 Diagnostic menu
7.1 Connecting to the Network controller console
port
For a diagnosis with a pc or laptop there is an installation diagnosis menu, ‘Diagnostics'. It is
not necessary to download all settings via a user interface. After connecting the hardware,
without an exchange being present, it can be checked, locally via a simple terminal program,
whether all hardware is operational.
There are many different programs, like Teraterm, which can emulate a VT100 terminal on a
PC. Using a simple laptop, diagnostics can be logged in via the serial port in the Polyx.
 Connect your PC for example to port “Console” from the Network controller. Use the
adapter shown below (available at Keyprocessor BV).
 Open a terminal program and make a connection. (e.g. Tera term)
 Select the COM-port of the PC connected to the Network controller.
 iPU-8: Choose a baud rate of “9600”, Data ‘8 bit”, Stop ‘1 bit’, Parity ‘None’ and flow
control “none”.
 Polyx: Choose a baud rate of “115200”, Data ‘8 bit”, Stop ‘1 bit’, Parity ‘None’ and
flow control “none”.

Keyprocessor Orion Specifications

General

Brand	Keyprocessor
Model	Orion
Category	Controller
Language	English